Cut Sheet

Chlor-Free® Non-Chlorinated Degreaser (Aerosol)
DISCLAIMER: This information is accurate to the best of CRC Industries’ knowledge or obtained from sources believed by CRC to be
accurate. Before using any product, read all warnings and directions on the label. All products should be tested for suitability on a particular
application prior to actual use. CRC Industries makes no representations or warranties of any kind concerning this data.
CRC Industries Industrial Products Division Warminster, PA 18974
Technical Service: [phone] Customer Service: [phone] CRC On-Line: [phone]
Literature Reorder #TDS105 CRC On-Line # 105 REV. 10/07
VI. Performance Characteristics
ASTM D-877 (Dielectric Strength)
6,000 volts
ASTM D-56 (Flash Point)
<0ºF (TCC)
ASTM D-1130 (KB Value)
106
VII. Directions
 To remove grease, oil, hydraulic fluids and related contaminants, spray until clean. For hard to reach
areas, use the extension tube.
 Air dry or dry with an absorbent cloth.
 If necessary, repeat application.
 Allow to dry thoroughly and vent before reactivating the system.
VIII. Package Description
Part Number Container Size
03185 20 oz Aerosol
IX. Disposal
Disposal requirements vary by state and local jurisdiction. All used and unused product should be disposed of in
conformance with local, state and federal regulations.
X. Special Use Warnings
Aerosol Cans
Contents extremely flammable. Do not smoke while spraying. Extinguish all flames, pilot lights, and heaters. Do not
puncture, incinerate or store above 120 F. Exposure to high temperatures may cause can to burst. Do not place in
direct sunlight or near any heat source. Aerosol cans will conduct electricity. Keep away from all live electrical
sources including battery terminals, solenoids, electrical panels and other electronic components. Failure to observe
this warning may result in serious injury from flash fire and/or electrical shock.
General
Use only in well ventilated area. Ventilation may be improved by opening a window or door or providing mechanical
assistance. Vapors will accumulate readily and may ignite. Avoid continuous breathing of vapor and spray mist.
Avoid contact with skin and eyes. If ventilation is not adequate, respiratory protection should be worn. For more
information regarding short term and long term exposure, review this product’s Material Safety Data Sheet.