SDS

Do not use water jet as an extinguisher, as this will spread the fire.
Unsuitable extinguishing
media
Contents under pressure. Pressurized container may rupture when exposed to heat or flame. This
product is a poor conductor of electricity and can become electrostatically charged. If sufficient
charge is accumulated, ignition of flammable mixtures can occur. Static electricity accumulation
may be significantly increased by the presence of small quantities of water or other contaminants.
Material will float and may ignite on surface of water. During fire, gases hazardous to health may
be formed.
Specific hazards arising from
the chemical
Firefighters must use standard protective equipment including flame retardant coat, helmet with
face shield, gloves, rubber boots, and in enclosed spaces, SCBA.
Special protective equipment
and precautions for firefighters
Fire-fighting
equipment/instructions
In case of fire: Stop leak if safe to do so. Move containers from fire area if you can do so without
risk. Containers should be cooled with water to prevent vapor pressure build up.
Extremely flammable aerosol. Contents under pressure. Pressurized container may rupture when
exposed to heat or flame.
General fire hazards
6. Accidental release measures
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Remove all
possible sources of ignition in the surrounding area. Keep out of low areas. Many gases are
heavier than air and will spread along ground and collect in low or confined areas (sewers,
basements, tanks). Wear appropriate protective equipment and clothing during clean-up. Avoid
breathing mist or vapor. Emergency personnel need self-contained breathing equipment. Do not
touch damaged containers or spilled material unless wearing appropriate protective clothing.
Ventilate closed spaces before entering them. Use appropriate containment to avoid
environmental contamination. Local authorities should be advised if significant spillages cannot be
contained. For personal protection, see section 8 of the SDS.
Personal precautions,
protective equipment and
emergency procedures
Keep combustibles (wood, paper, oil, etc.) away from spilled material. This product is miscible in
water. Prevent product from entering drains. Stop the flow of material, if this is without risk. Wipe
up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual
contamination. For waste disposal, see section 13 of the SDS.
Methods and materials for
containment and cleaning up
Avoid release to the environment. Inform appropriate managerial or supervisory personnel of all
environmental releases. Prevent further leakage or spillage if safe to do so. Avoid discharge into
drains, water courses or onto the ground. Use appropriate containment to avoid environmental
contamination.
Environmental precautions
7. Handling and storage
Obtain special instructions before use. Do not handle until all safety precautions have been read
and understood. Minimize fire risks from flammable and combustible materials (including
combustible dust and static accumulating liquids) or dangerous reactions with incompatible
materials. Pressurized container: Do not pierce or burn, even after use. Do not use if spray button
is missing or defective. Do not spray on a naked flame or any other incandescent material. Do not
smoke while using or until sprayed surface is thoroughly dry. Do not cut, weld, solder, drill, grind,
or expose containers to heat, flame, sparks, or other sources of ignition. Use caution around
energized equipment. The metal container will conduct electricity if it contacts a live source. This
may result in injury to the user from electrical shock and/or flash fire. Protect containers from
physical damage; do not drag, roll, slide, or drop. When moving containers, even for short
distances, use a cart (trolley, hand truck, etc.) designed to transport containers. Avoid breathing
mist or vapor. Avoid contact with eyes, skin, and clothing. Avoid prolonged exposure. Pregnant or
breastfeeding women must not handle this product. Should be handled in closed systems, if
possible. Use only in well-ventilated areas. Wear appropriate personal protective equipment.
Wash hands thoroughly after handling. Avoid release to the environment. Observe good industrial
hygiene practices. For product usage instructions, see the product label.
Precautions for safe handling
Level 3 Aerosol.
Pressurized container. Protect from sunlight and do not expose to temperatures exceeding
50°C/122 °F. Do not puncture, incinerate or crush. Do not handle or store near an open flame,
heat or other sources of ignition. This material can accumulate static charge which may cause
spark and become an ignition source. Avoid spark promoters. These alone may be insufficient to
remove static electricity. Store in a well-ventilated place. Keep out of the reach of children. Store
away from incompatible materials (see Section 10 of the SDS).
Conditions for safe storage,
including any incompatibilities
3 / 11
Material name: QD® Electronic Cleaner
No. 05103 (Item# 1003719) Version #: 02 Revision date: 08-08-2017 Issue date: 08-08-2017
SDS US