Certifications 2

SECTION 5: Firefighting measures
Will burn if involved in a fire.
General fire hazards
5.1. Extinguishing media
Foam. Dry chemicals. Carbon dioxide (CO2).
Suitable extinguishing
media
Do not use water jet as an extinguisher, as this will spread the fire.
Unsuitable extinguishing
media
During fire, gases hazardous to health may be formed.
5.2. Special hazards arising
from the substance or mixture
5.3. Advice for firefighters
Self-contained breathing apparatus and full protective clothing must be worn in case of fire.
Special protective
equipment for firefighters
Cool containers exposed to heat with water spray and remove container, if no risk is involved.
Containers should be cooled with water to prevent vapour pressure build up.
Special fire fighting
procedures
Use standard firefighting procedures and consider the hazards of other involved materials.
Specific methods
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Wear appropriate protective equipment and clothing during clean-up. Do not touch damaged
containers or spilled material unless wearing appropriate protective clothing.
For non-emergency
personnel
Keep unnecessary personnel away. Ensure adequate ventilation. Local authorities should be
advised if significant spillages cannot be contained. Use personal protection recommended in
Section 8 of the SDS.
For emergency responders
Avoid discharge into drains, water courses or onto the ground.
6.2. Environmental precautions
Stop leak if you can do so without risk. Move the cylinder to a safe and open area if the leak is
irreparable. Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate
area). Keep combustibles (wood, paper, oil etc) away from spilled material. This product is
miscible in water. Absorb in vermiculite, dry sand or earth and place into containers. Following
product recovery, flush area with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
6.3. Methods and material for
containment and cleaning up
For personal protection, see section 8 of the SDS. For waste disposal, see section 13 of the SDS.
6.4. Reference to other
sections
SECTION 7: Handling and storage
Pressurised container: Do not pierce or burn, even after use. Do not use if spray button is missing
or defective. Do not spray on a naked flame or any other incandescent material Do not smoke
while using or until sprayed surface is thoroughly dry. Do not cut, weld, solder, drill, grind, or
expose containers to heat, flame, sparks, or other sources of ignition. Ground and bond containers
when transferring material. Do not re-use empty containers. Avoid contact with eyes. Avoid
prolonged or repeated contact with skin. Avoid prolonged exposure. Use only in well-ventilated
areas. Wear appropriate personal protective equipment. Observe good industrial hygiene
practices.
7.1. Precautions for safe
handling
Contents under pressure. Do not expose to heat or store at temperatures above 120°F/49°C as
can may burst. Do not puncture, incinerate or crush. Do not handle or store near an open flame,
heat or other sources of ignition. Store away from incompatible materials (see Section 10 of the
SDS).
Storage class (TRGS 510): 2B (Aerosol dispensers and lighters)
7.2. Conditions for safe
storage, including any
incompatibilities
Not available.
7.3. Specific end use(s)
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
No exposure limits noted for ingredient(s).
Occupational exposure limits
No biological exposure limits noted for the ingredient(s).
Biological limit values
Follow standard monitoring procedures.
Recommended monitoring
procedures
Derived no effect levels (DNELs)
General Population
NotesAssessment factorValueComponents
1,2-BENZISOTHIAZOL-3(2H)-ONE;1,2-BENZISOTHIAZOLIN-3-ONE (CAS 2634-33-5)
Long-term, Systemic, Dermal 200 Repeated dose toxicity0.345 mg/kg bw/day
Long-term, Systemic, Inhalation 50 Repeated dose toxicity1.2 mg/m3
SDS UK
Material name: Inox Kleen - Manufacturers
BDS002536AE Version #: 01 Issue date: 27-May-2021
3 / 10