Data Sheet

Technical data sheet

Lectra Clean II

Reference :

10107

Manufactured by :

CRC Industries Europe bvba

Touwslagerstraat 1

9240 Zele Belgium

Tél.: (32)(0) 52/45.60.11 Fax : (32)(0) 52/45.00.34

www.crcind.com

1/3

1. General description

Heavy-duty cleaner for

degreasing and decarbonising

electro-mechanical metal parts

and equipment.

2. Features

• Controled evaporation for enhanced cleaning action.

• High flash point for application safety.

• Low odor.

• Non conductive.

• Non corrosive.

• Does not leave a residue.

• Convenient 360° (including inverted position) spray valve for aerosols.

• High purity CO2 propellant, giving an active product content of 95%.

3. Applications

• Electro-mechanical assemblies.

• Electrical aggregates.

• Pumps.

• Cleaning mechanical parts.

PAGE 1
Technical data sheet Lectra Clean II Reference : 10107 1. General description Heavy-duty cleaner for degreasing and decarbonising electro-mechanical metal parts and equipment. 2. Features • • • • • • • • Controled evaporation for enhanced cleaning action. High flash point for application safety. Low odor. Non conductive. Non corrosive. Does not leave a residue. Convenient 360° (including inverted position) spray valve for aerosols. High purity CO2 propellant, giving an active product content of 95%. 3.
PAGE 2
Technical data sheet Lectra Clean II Reference : 10107 • Wire ropes. • Handling equipment. 4. Directions • Spray liberally and allow to run off. • Use extension tube for more precise application. • When applied by dipping, agitation accelerates the action. • Slight heating (up to 40°C) enhances cleaning action in dipping baths. May also be applied by wiping with a clean rag or by brushing. To clean equipment interior, covers, plates, etc. should be removed prior to product application.
PAGE 3
Technical data sheet Lectra Clean II Reference : 10107 Bulk 20 L 200 L 4x5 L 7. Remarks Drying Time Parts cleaned with CRC Lectra Clean II will not dry as rapidly as those cleaned with chlorinated or low flash point solvents. Drying time will depend considerably on surface geometry and environmental conditions (temperature, % humidity, ventilation, ...).