Datasheet

Manufactured by :
CRC Industries Europe BVBA
Touwslagerstraat 1 – 9240 Zele – Belgium
Tel (32) (0) 52/45.60.11 Fax (32) (0) 52/45.00.34
www.crcind.com
TECHNICAL DATA
1/2
CRC POWER STICK
Permanent high strength adhesive
Ref. : 10117
1. GENERAL DESCRIPTION
CRC Power Stick is a high strength adhesive, formulated without Methylene Chloride or other
chlorinated solvents.
2. FEATURES
• High strength formulation
•
Longer open bond time - allows large areas to be covered before film dries
•
Economical, good coverage
•
Free from chlorinated solvents
3. APPLICATIONS
Spray Adhesive Power Stick will provide high-strength bonds in many different areas:
• Chipboard and Concrete
• Insulation Materials and Carpets
• Canvas and Leather
• Paper, Wood and Cork
• Metal, Plastic and Rubber
4. DIRECTIONS
• Apply an even coating to both surfaces to be bonded from 25 – 30 cm distance.
• Wait until the adhesive is tack-dry.
• Bond the surfaces together using firm pressure.
• To prevent blockages, invert the can after use and spray to clear the nozzle.
N.B. May affect certain plastics. Always test on a small, inconspicuous area before
general use.
• A safety data sheet (MSDS) according to EU directive 91/155/EEC and amendments is
available for all CRC products.
5. TYPICAL PRODUCT DATA (without propellant)
Appearance : Clear, opaque liquid
Odour : Acetone
SG @ 25°C : 0.68
Polymer type : Styrene Isoprene Copolymer
Tack time : Approximately 2-10 minutes
Bonding time : Maximum adhesion in 12/24 hours
Temperature range : Up to 50°C (dried film)
Solubility : Soluble in some solvents,
insoluble in water
Recommended solvents : CRC Industrial Degreaser