Data Sheet

Technical data sheet
Dry Lube
Reference : 10255
Manufactured by :
CRC Industries Europe bvba
Touwslagerstraat 1
9240 Zele Belgium
Tél.: [phone] Fax : [phone]
www.crcind.com
2/1
• Release agent for moulding plastic and rubber.
• Transfer of CRC Dry Lube to moulded parts is negligible, minimizing interference with post finishing operations.
4. Directions
• Shake well before use.
• Shake until the agitator ball moves freely in the can.
• To remove residues or excess product, use one of the CRC cleaners.
• Spray from a distance of approximately 20 - 30 cm.
• Allow to dry at room temperature.
• Do not use on energized equipment.
• A safety data sheet (MSDS) according to EC Regulation N° 1907/2006 Art.31 and amendments is available
for all CRC products.
5. Typical product data (without propellant)
Appearance Liquid.
Color Off-white.
Odor Solvent.
Density 0.75 g/cm3 (@ 20°C).
Flash Point < 0 °C
Density active product 2.16 g/cm3 (@ 20°C).
Operating temperature active product max 250 °C
Drying time active product 15 min
6. Packaging
Aerosol 12x400 ML Ref. : 30519
12x500 ML Ref. : 30520
All statements in this publication are based on service experience and/or laboratory testing. Because of the wide variety of equipment,
conditions of use and the unpredictable human factors involved, we recommend that our products are tested on-the-job prior to use. All
information is given in good faith but without warranty neither expressed nor implied. This Technical Data Sheet may already have been
revised as a result of a change in legislation, availability of components or newly acquired experiences. The latest and only valid version of
this Technical Data Sheet will be sent to you upon simple request or can be found on our website: www.crcind.com
We recommend that
you register on our website for this product, thus enabling you to automatically receive any future updates.
Version
CRC_GREEN-DRY_LUBE-20131003