Installation Manual

Step 2. Install aluminum extrusions (L) and (R) to base (Ba)
Step 1. Place (L) on the left and keep the direction of the base
(Ba) facing front；
Step 2. Place the aluminum profile (L) vertically over the left side
frame of the base (Ba), be careful that the (L) profile has the
threaded holes with the short sides facing downwards. Using
the M5x45 screws and washers, pass through bottom hole of
the aluminum profile at the left side of the base (Ba), align the
threaded hole at the bottom of the aluminum profile (L), and
tighten the screw with an hexagon wrench;
Step 3. Place the aluminum profile (R) vertically over the right
side frame of the base (Ba). Note that the (L) profile has through
holes with the short sides facing downwards. Also note that the
holes are to the left (see diagram) to ensure that the aluminum
profiles are oriented correctly. , Using M5x45 screws and
washers, pass them through bottom hole of the aluminum
profile at the right side of the base (Ba), align the threaded hole
at the bottom of the aluminum profile (R), and tighten with the
4mm Allen key.
Prepare the following parts:
a. M5x45 socket head hex screws (4x)
b. M5 washer (4x)
c. Aluminum profiles (L) (1x)
d. Aluminum profiles(R) (1x)
e. Base (Ba) (1x)
f. 4mm Allen key