Installation Manual

Step 7. X-axis assembly (part 1)
Step 1. Assembly of aluminum profile (B1) and extrusion
assembly (E). Aluminum profile (B1) is shown in the diagram
on the left(1). Pay attention to the position and direction of
the large hole. Align the hole of extrusion assembly (E) with
the threaded hole of aluminum profile (B1), it should be
noted that the hole has two plates, which aresecured with
M4*16 screws, and fixed to the second profile plate and the
aluminum profile (B1). Use a suitable Allen key to tighten the
screws.
Step 2. Adjust the direction of the nozzle kit(N) as shown in
Figure (3). Hold one end of the timing belt in the slot on the
right side underneath the nozzle kit (N), and the other end in
the path shown in Figure (2). Go through the extrusion
assembly (E), bypass the synchronizing wheel, and slide the
nozzle kit (N) from the left into the aluminum profile when
the path of figure (2) completes three quarters (in the red
line position in Figure 2). Then, complete the path of the belt
as shown in Figure (2). Then, stick the other end of the belt
to the slot on the left side below the nozzle kit (N).
Step 3. Position the pulley assembly (K2) in the position
shown in Figure (3), align the threaded hole in the aluminum
profile on the left side of the profile (B1), pass it with the
M4*16 screw, and use the 2.5mm hexagon wrench to lock
the screw;
Note. As you complete easy step, be sure to place the
parts according to the diagram on the left side.