User Manual

- 17 -
We can click on the gray ring on the window to control the motion of the XYZE
axis. "0.1, 1, 10, 100" are the each amount of motion. The text box in the lower right
corner can be input G code to control. If you are not familiar with it, please do not
change anything. Click “Print” to start printing. Please be careful during printing to
avoid printing failure.
*If you cannot connect properly, please install the corresponding driver or
download the third-party driver software.
X,Y,Z Zero
X-axis Zero
Y-axis Zero
Z-axis Zero