V1.
≤180mm/s,Normal|正常为 60mm/s
30
Notes: If the T-type screw is inclined, please slightly loosen the 4 screws on the Z-axis motor and make the screw rod vertical through moving the T-nut connector to, and then tighten the screws on the motor.
The rubber pad at the bottom of machine will be slightly deformed under stress. If this happens when you install the acrylic plate, please loosen the foot pad first, and then lock them after installing the acrylic board.
A B Loosen the screws at A and B in the figure, and press the corrugated tube into the hold-down block to prevent them from hanging down on the Hotbed.
After installation, to ensure each V-wheel is well combined with the profile. Please check as follows before printing. 1. Z-axis: Check whether the 8 pieces of V wheels is idling; 2. X-axis: Check whether the 4 pieces of V wheels on the nozzle mounting plate are idling; 3. Y-axis: Check whether the 4 pieces of V wheels on the left and right sides of the mounting plate are idling; If there is idling, please adjust the eccentric nut.
This machine can print at a fast speed, but it is recommended to print at normal speed!Notes: the temperature of the nozzle is set according to the printing speed. Take PLA as an example: 本机器支持高速打印，但建议以正常速度打印！注意：不同速率时，喷嘴打印温度需相应调整设置，创想配送PLA推荐设置参数： 200 0.00 210 0.00 60 print speed 打印速率 Print temperature 打印温度 200 210 60 100% 200% 300% Around 200℃ 200℃左右 Around 210℃ 210℃左右 Around 220℃ 220℃左右 The printing temperature is different owing to the variety of PLA filaments.
