Leveling Nut | 前门
300*225*380mm 0.1-0.
Level the Platform 3 调平平台 3. Offset value valid of automatic leveling and the default automatic leveling return home in printing process which make an excellent result of printing when automatic leveling starting. 4. Offset value invalid of automatic leveling and it will reduce the time to leveling printing process when automatic leveling shut down. 0.132 -0.015 -0.005 -0.057 -0.055 0.043 -0.365 -0.067 -0.022 -0.087 0.105 29 0 29 0 0.040 0.080 -0.827 -0.084 -0.033 -0.022 -0.044 -0.035 -0.
4
5
Level the Platform 6 调平平台 Auto-leveling If you need to realize the auto-leveling, you can have a setting: 0.132 -0.015 -0.005 -0.057 -0.055 0.043 -0.365 -0.067 -0.022 -0.087 0.105 29 0 29 0 0.040 0.080 -0.827 -0.084 -0.033 -0.022 -0.044 -0.035 -0.097 -0.092 -0.092 -0.132 -0.067 -0.085 自动调平 如果您需要自动调平,可以在下面界面中进行设置: 0.132 -0.015 -0.005 -0.057 -0.055 0.043 -0.365 -0.067 -0.022 -0.087 0.105 29 0 Notes: 29 0 0.040 0.080 -0.827 -0.084 -0.033 -0.022 -0.044 -0.035 -0.
7 Preheat 预热 When turning ABS to PLA, the nozzle temperature should be raised to 240 ℃, 29 0 29 0 29 0 29 0 and then replace with PLA. After PLA reaches the nozzle, to feed-in about 150mm to extrude the remaining ABS, and then the nozzle temperature is reduced to 200 ℃ and start to print.
8 Preheat 预热 方法1、 当ABS打印完成后,需要打印PLA时, 29 0 29 0 29 0 29 0 PLA耗材。 PLA到达喷嘴处后,然后将 耗材进料150mm,让喷头处的ABS余 料尽量挤出,然后将喷嘴温度降低为 方法2、 29 先将喷嘴升高到240℃,然后更换为 200℃再来打印。 0 29 300 81 110 38 0~300℃ 0 29 0 29 200 0
9
10
11 CR-5 Pro
12 G G G 195 195 45 45 G shugen test huba test 2/20 1 SD卡 G G G 195 195 45 45 G shugen test huba 1 test 2/20 打印