User Manual

The only suitable Expression Pedal for your PRODYSSEY is

the model "Yamaha

FC7" (or 100% compatible). Other mo-

dels MUST NOT be connected as these may cause permanent

damage to your PRODYSSEY!

The PRODYSSEY ASB automatically recognizes a connected foot

slider once the unit it switched on; however, it is activated only after

it has been fully pressed and released.

LFO

The PRODYSSEY’s LFO features sine and

square waveforms – you choose the wave form

at the modulation destination. In addition, the

LFO functions as a timing signal for the Samp-

le/Hold and for the envelopes in the repeat

mode.

LFO Freq

This sets the LFO frequency. The range is from 0.2 Hz to 20 Hz.

Sample/Hold Mixer

This is where the signals that provide the source for the

sample/hold are mixed. The mixed signal can also be

used directly as a modulation source in various areas.

For example, noise or individual oscillators can be used

as modulation sources. You can mix your choice of any

two of four available sources. You can choose between

sawtooth and square from Oscillator 1 and noise or

square from Oscillator 2.

The faders adjust the signals’ intensities that are assi-

gned to the sample/hold function or to a direct modula-

tion destination. There are two faders to mix the signals

and two switches to select the source. A selector switch

directly below each fader determines the signal to be

mixed. For channel 1 these are sawtooth and square,

and for channel 2 you can choose between the noise

generator or square.