User Manual

21
Having selected 'preset', you can press the 'user' button to switch
between the factory and user banks. (Please note that this function
will not work unless you press the 'preset' button first.)
User (secondary function)
The 'user' button has a secondary function which is activated by
holding it down for one second. This sends current front panel
settings to the PRODYSSEY's sound engine (and to the Remote
Software) so you can hear them in action. (Hidden parameters on
the Remote Software's 'Add page' will be set to their default valu-
es).
Store
To save a preset, press the 'store' button. The LED will start blinking
- now choose a preset number by turning the data wheel or by using
the 'down/up' buttons and press 'store' again. At this point the LED
will start flickering - press the 'store' button until the LED light goes
off. The preset is now stored under the chosen preset number.
Effects
Pressing the 'bypass' button turns all effects off. (Depending on
your effects settings, this might make some presets sound a little
louder.) Once selected, the 'bypass' LED will light and all effects will
be muted - pressing the button again cancels the 'bypass' and turns
the effects back on.
To choose an effects program, press the 'program' button and use
the data wheel or 'down/up' buttons to make a selection. There are
a total of five programs offering various combinations of chorus and
delay. As you can see from the 'effects programs' table below, the
three effects parameters (labelled 'Param 1 - 3' on the control pa-
nel) differ from program to program.