Use and Care Guide

© 2020 Createx Colors Page 3 of 3
Top-Coating with a Clear (cont’d.)
Fabric & General Hobby:
Apply 5603 Matte Top-Coat & 5604 Gloss Top Coat for a
light protective coating.
• Thin 5603 & 5604 Top-Coat 5% - 10% per
volume with 4011 Reducer.
• Apply ~ 25 – 30 psi with large-tip-sized airbrush
• Apply 2 – 3 medium, non-wetted coats, allowing
each coat ~ 5 – 10 minutes drying in between
coats.
• Top Coat is supple after drying, better suited for
fabric. For leather, use Createx UVLS Clears as
top-coat.
• Heat-set after Top Coat dries for washfast
results on t-shirt and fabrics.
Exterior, Sign, Plastic, Leather and More:
Apply Createx UVLS Clears: 4050 Gloss, 4051 Satin and
4052 Matte Clears.
• Thin UVLS Clears 5% - 10% per vol. with 4011
Reducer
• Apply with large tip-sized airbrush ~ 25 psi, or
spray-gun 1.2 – 1.4mm ~ 20 psi inlet
• For application onto hard-plastics, glass and
other hard-to paint substrates, apply UVLS 4050
Gloss Clear as an adhesive primer, then apply
Createx Airbrush Colors after 4050 Clear has
dried. 4050 UVLS Clear has exceptional
adhesion to any substrate except silicone.
• For more info, refer to UVLS Clears TDS
Cleaning from Airbrush or Spray-Gun
Airbrush Colors are best rinsed from the airbrush or spray-gun
with 5618 Airbrush Cleaner or 4011 Reducer.
Use 4008 Restorer as a rinse for final clean to remove dried
paint from metallic parts. Rinse well with water after using
4008.
Cleaning after Airbrush Colors Cure
Colors should only be cleaned after the paint has thoroughly
dried, best 48 hours. Use a solvent-based degreaser or
odorless mineral spirits to clean
Createx Airbrush Colors.
Health & Safety
Use in a well-ventilated area. Avoid contact with eyes.
Wash hands thoroughly with soap and warm water
after use. Do not ingest. When spraying or sanding, use
a properly fitting NIOSH approved respirator per the
manufacturer’s instructions. Eye contact: Rinse with
clean water for 15 minutes. Seek medical attention.
Inhalation: Use in in well ventilated areas and wear a NIOSH
approved respirator.
Refer to Createx Airbrush Colors SDS for additional
information.
Manufactured by:
Createx Colors
PO Box 120, 14 Airport Park Rd
East Granby, CT 06026
800.243.2712 | 860.653.5505
[e-mail]