Installation Guide

2
BP 018
Assembly Instructions:
1. Attach Eye Bolt side of (4) chains to (2) Swing Handles as shown, using an open end
wrench to hold the Lock Nut in place while spinning the Eye Bolt with a
screwdriver until tight as shown in (Fig. 1). Once fully tightened, make certain all
(4) Eye Bolts are aligned, as shown in (Fig. 2).
2. Attach swing Handles to swing Seat as shown in (Fig. 3).
Note: Once all lock nuts are tightened, (3) threads should protrude from each Lock
Nut.
3/4’’ Flat Washer
Lock Nut
7/8’’ Flat Washer
Lock Nut
Handle
Seat
1/2’’ x 7-1/2’’
Hex Head Bolt
Eye Bolt
Tighten Lock Nut
until three (3) threads
are exposed.
Tighten Lock Nut
until three (3) threads
are exposed.
Eyebolts
Handle Attach
Eye Bolt
ASSEMBLY
BP 018
Fig. 1
Fig. 2
Fig. 3
3/4’’ Flat Washer
7/8’’ Flat Washer
7/8’’ Flat Washer
7/8’’ Flat Washer