User's Manual

3. Easy steps to configure the evaluation boards
The GUI is required to configure the evaluation boards for different applications.
Step 1: Double-click on the GUI Icon or shortcut to run the program.
Step 2: Read the limited license carefully and click I Agree to proceed.
Step 3: Make sure the evaluation board is turned on.
Step 4: Connect the serial cable between your notebook/PC and the evaluation board.
Step 5: Setup your Com Port in Com Port Settings.
You need to setup your com port for the first time.
There are 99 options to choose from COM1 to COM99.
Click Apply to proceed.
You should see READY in Module Status.
If you see NOT FOUND, please check that the serial
cable is not disconnected or loose.
Step 6: At the top-left corner of the GUI, click Help, then click About.
The current firmware version is shown as Evaluation Kit Version.
The current GUI version is shown as GUI Version.
12