User's Manual

Step 7: Setup your choice of application in the Application Selection (Power-up Settings).
Application Selection
2 Speaker ACK
3 Speaker ACK
4 Speaker ACK
2 Speaker NACK
4 Speaker NACK
Headset 2 NACK down 2 ACK up
Continuous RX or TX
2 Speaker ACK 44.1
2 Speaker NACK 44.1
4 Speaker NACK 44.1
Microphone
Click Config to configure the evaluation board.
ACK is the Active Acknowledgement protocol. MU will always acknowledge to CU for every
packet received from the CU.
NACK is the Not Active Acknowledge protocol. MU will only acknowledge to CU for packet not
received within expected duration or when MU received an error packet.
Continuous RX and TX is intended for RF testing only.
13