User's Manual
Table Of Contents
- Congratulations!
- System Requirements
- About Your Headset
- Setting Up Your Headset
- Wearing the headset
- Using the Wireless Features
- Step 1: Turn on the headset
- Step 2: Press the Connect button on the headset
- Step 3: Press the Connect button on the USB wireless transmitter
- Step 4: Successful Pairing
- World of Warcraft Audio Control Panel
- How to use Profiles
- Illumination Settings
- How to use Illumination
- THX TruStudio PC Settings
- How to set THX TruStudio PC
- Game Audio Settings
- How to change VoiceFX and EQ
- Key Bindings Settings
- How to change Key Bindings
- Foot Switch Settings (Optional - Foot Switch sold separately)
- How to configure the Foot Switch
- Using Your Headset
- Software Suite
- Troubleshooting
- General Specifications
- Safety Information
- Declaration of Conformity
- Regulatory Information
Setting Up Your Headset
Before using your headset, you should install the drivers and applications for it by
following the steps below. This enables you to enjoy the full features of your
headset such as THX TruStudio PC audio enhancements and customizable LED
colors.
Step 1: Charge your headset
For first use, connect your headset to your computer’s USB port using the USB
power charging cable and charge for at least 2.5 hours. Turn off the headset while
charging. The Power LED flashes red when charging, and lights up red when fully
charged.
Step 2: Download the software
Visit www.soundblaster.com/products/wowheadset_wireless to download the
latest drivers and applications available for your headset.
Step 3: Connect the transmitter to your computer’s USB port
NOTE
If prompted for the audio drivers, click the Cancel button.