User Manual
Table Of Contents
- About Your Receiver
- About Your Remote Control
- Setting Up Your Receiver
- Setting Up Two or More Receivers
- About Broadcasting and Zone Control
- Manual Pairing
- Using Your Receiver
- Using Your Wireless Features
- Troubleshooting Wireless Features
- FAQs
- General Specifications
- Safety Information
- Declaration of Conformity
- Regulatory Information
Press the Connect button on your first receiver 14
Step 2: Press the Connect button on your first receiver
This must be done within three minutes after pressing the Connect button
on the transmitter (Step 1). Once the transmitter and receiver are paired
successfully, the Link/Connect LED on both units light up green and remain
on. The first receiver to be paired will be assigned to Zone 1.
IMPORTANT
DO NOT press the Connect button repeatedly on your transmitter
or receiver before a pairing process is complete or else you may
not be able to perform the correct zone assignment for your
receivers.
NOTE
• For more information about the Link LED, see “Understanding
the Link LED” on page 17.
• For troubleshooting information, see “Troubleshooting Wireless
Features” on page 21.
1 auto 2
5V DC
LINK /
CONNECT
1 auto 2
5V DC
LINK /
CONNECT