User Manual
Table Of Contents
- About Your Receiver
- About Your Remote Control
- Setting Up Your Receiver
- Setting Up Two or More Receivers
- About Broadcasting and Zone Control
- Manual Pairing
- Using Your Receiver
- Using Your Wireless Features
- Troubleshooting Wireless Features
- FAQs
- General Specifications
- Safety Information
- Declaration of Conformity
- Regulatory Information
Using Your Receiver 16
Using Your Receiver
Turning on your receiver or enabling Standby mode
Press the Power/Standby button on your remote control to turn on the
receiver, or enable Standby mode.
Returning to factory default settings
Return to the factory default settings if you want to
• revert to the original volume setting,
• reset your zone numbering sequence, or
• “unpair” a receiver.
Press and hold the Previous/Rewind and Next/Fast forward buttons on your
receiver together for five seconds. The Power LED goes off for two seconds
before lighting up again.
NOTE
You can also use the Play/Pause button on your receiver. See
“About Your Receiver” on page 2.
NOTE
The receiver pairs with your transmitter automatically if both
return to factory default settings.