User Manual
Table Of Contents
- About Your Receiver
- About Your Remote Control
- Setting Up Your Receiver
- Setting Up Two or More Receivers
- About Broadcasting and Zone Control
- Manual Pairing
- Using Your Receiver
- Using Your Wireless Features
- Troubleshooting Wireless Features
- FAQs
- General Specifications
- Safety Information
- Declaration of Conformity
- Regulatory Information
Using Your Wireless Features 20
To activate saved receivers only
Below is an example of how you can save your favorite combination of
receivers (for example, receivers 1 and 3) and activate them later using the
Zone button.
For MovieWorks HD, Xdock Wireless or Xmod Wireless
1 Ensure that only receivers 1 and 3 are activated (turned on). If you have four
manually paired receivers that are all activated, deactivate receivers 2 and 4
by pressing the Zone 2 and 4 buttons.
2 Press the Zone button. Your transmitter will save this combination
(zones 1 and 3). Receivers 1 and 3 will then be on Standby mode.
3 Press the Zone button. Only receivers 1 and 3 will be activated.
4 To deactivate receivers 1 and 3, press the Zone button again.
For Sound Blaster X-Fi Notebook
1 Ensure that only receivers 1 and 3 are activated (turned on). Zone buttons 1
and 3 should be highlighted in Entertainment Mode. If you have four
manually paired receivers that are all activated, deactivate receivers 2 and 4
by clicking the Zone 2 and 4 buttons.
2 Click the Enable Wireless Music Control check box to deselect it. Receivers
1 and 3 will then be on Standby mode.
3 Click the Enable Wireless Music Control check box again to select it. Only
receivers 1 and 3 will be activated.
NOTE
Your transmitter can only save and reactivate one combination of
receivers. It remembers the last combination of activated
receivers just before the Zone button is pressed.