User's Manual
Table Of Contents
- Congratulations!
- System Requirements
- About Your Devices
- Setting Up Your Wireless System
- Using Creative Music Server
- Using the Controller
- Playing and Managing Music
- Managing Broadcast and Zone modes
- Using Your Audio Device
- Software Suite
- Standalone Operation (Optional)
- Troubleshooting
- General Specifications
- Safety Information
- Regulatory Information
Pair the Receiver 10
Pairing Additional Receivers
If you wish to reset your transmitter or add more receivers later, follow the steps below:
1 Click the Wireless Control Setup icon in Creative Music Server.
2 Click the Wizard button.
3 Select the Add a wireless receiver
option, then follow the instructions on the
screen.
4 Press the Connect button on the receiver
to complete the pairing with the
transmitter.
Resetting Your Devices
If you wish to reset the zones of your wireless system and start afresh with your wireless
setup, do the following to reset your devices:
• To reset your Transmitter:
- Press and hold the Transmitter’s Connect button for five seconds, OR
- In Creative Music Server, run the Wireless Setup Wizard and select the Reset the
transmitter for a completely new setup option.
• To reset your Controller, tap Settings -> Wireless Settings -> Wireless Reset.
• To reset your Receiver, press and hold the Receiver’s Connect button for five seconds.
NOTE
If you reset one device, you should also reset the other devices in your wireless
system, and then pair them again.