User's Manual
Table Of Contents
- Creative Sound Blaster Wireless Entertainment
- Contents
- Introduction
- Your Sound Blaster Wireless Entertainment At A Glance
- Getting Started
- Using Your Remote Control
- About Music Files
- Frequently Asked Questions
- Maintenance and Safety Advice
- Technical Specifications
- Glossary
- Ad-hoc mode
- Antenna
- Access Point (AP)
- Bandwidth
- BSS (Basic Service Set)
- DHCP (Dynamic Host Configuration Protocol)
- Dynamic IP address
- Encryption
- IEEE 802.11
- IEEE 802.11b
- IEEE 802.11g
- Infrastructure mode
- IP (Internet Protocol)
- IP address
- LAN (Local Area Network)
- MAC (Media Access Control) address
- Router
- SSID (Service Set Identity)
- Static IP address
- TCP/IP (Transmission Control Protocol/ Internet Protocol)
- USB (Universal Serial Bus)
- WEP (Wired Equivalent Privacy)
- Wi-Fi
Using Your Remote Control 4-5
To display the Info menu
1. Press the MENU button.
2. Scroll to the Info option and press the Right button.
Using one
Remote
Control with
different
Wireless MP3
Receivers
If you have more than one Wireless MP3 Receiver, you can use one Remote Control
to control all the Wireless MP3 Receivers. However, you can only control one
Wireless MP3 Receiver at a time. To select the Wireless MP3 Receiver your Remote
Control controls, you need to assign the Remote Control to the Wireless MP3
Receiver.
To assign a Remote Control to a Wireless MP3 Receiver
1. Press and hold the MODE button on the Remote Control until the LED
indicator on the Wireless MP3 Receiver starts blinking.
2. Press the FIND REMOTE button on the Wireless MP3 Receiver.
The Remote Control is now assigned to this Wireless MP3 Receiver. Repeat this
procedure to assign the Remote Control to different Wireless MP3 Receiver.
Checking the
Battery Status
The LCD may display one of the following icons to indicate the battery status:
❍ Batteries are full
❍ Batteries are 60% full
❍ Batteries are 30% full
❍ Replace your batteries as soon as you can