User's Manual
Table Of Contents
- Creative Sound Blaster Wireless Music
- Contents
- Introduction
- Your Sound Blaster Wireless Music At A Glance
- Getting Started
- Using Your Remote Control
- Configuring Settings
- About Music Files
- Frequently Asked Questions
- Maintenance and Safety Advice
- Technical Specifications
- Glossary
- Ad-hoc mode
- Antenna
- Access Point (AP)
- Bandwidth
- BSS (Basic Service Set)
- DHCP (Dynamic Host Configuration Protocol)
- Dynamic IP address
- Encryption
- IEEE 802.11
- IEEE 802.11b
- IEEE 802.11g
- Infrastructure mode
- IP (Internet Protocol)
- IP address
- LAN (Local Area Network)
- MAC (Media Access Control) address
- Router
- SSID (Service Set Identity)
- Static IP address
- TCP/IP (Transmission Control Protocol/ Internet Protocol)
- USB (Universal Serial Bus)
- WEP (Wired Equivalent Privacy)
- Wi-Fi
Getting Started 3-5
Step 3: Set up
Wireless
Receiver
1. Decide where you would like to place your Wireless Receiver. For optimum
performance, make sure your Wireless Receiver is placed on a flat surface that
is at least 50 cm (20 inches) from the floor, and where there is minimum
obstruction between your Wireless Receiver and your wireless router or access
point.
2. Connect your Wireless Receiver to speakers or a home stereo system (both
available separately).
Connecting to speakers
You can either connect speakers to the LINE OUT jacks or the OPTICAL OUT
connector of your Wireless Receiver.
RCA-to-miniplug cable
Audio input jack of 2 or 2.1
channel speakers
Figure 3-4: Connecting 2.1 channel speakers to the LINE OUT jacks of
your Wireless Receiver