User's Manual
Table Of Contents
- Creative Sound Blaster Wireless Music
- Contents
- Introduction
- Your Sound Blaster Wireless Music At A Glance
- Getting Started
- Using Your Remote Control
- Configuring Settings
- About Music Files
- Frequently Asked Questions
- Maintenance and Safety Advice
- Technical Specifications
- Glossary
- Ad-hoc mode
- Antenna
- Access Point (AP)
- Bandwidth
- BSS (Basic Service Set)
- DHCP (Dynamic Host Configuration Protocol)
- Dynamic IP address
- Encryption
- IEEE 802.11
- IEEE 802.11b
- IEEE 802.11g
- Infrastructure mode
- IP (Internet Protocol)
- IP address
- LAN (Local Area Network)
- MAC (Media Access Control) address
- Router
- SSID (Service Set Identity)
- Static IP address
- TCP/IP (Transmission Control Protocol/ Internet Protocol)
- USB (Universal Serial Bus)
- WEP (Wired Equivalent Privacy)
- Wi-Fi
Getting Started 3-7
Connecting to a home stereo system
You can either connect a home stereo system to the LINE OUT jacks or the
OPTICAL OUT connector of your Wireless Receiver.
• On your home stereo
system, connect the
RCA cable to either
the CD inputs or the
auxiliary inputs (or
other inputs if these
are unavailable).
• When you turn on
your home stereo
system, make sure
that the stereo
receiver or AV
Amplifier is in the
correct input mode.
For example, make
sure you select
auxilliary mode if
your Wireless
Receiver is
connectied the
auxiliaryinputs.
Figure 3-6: Connecting a home stereo system to the LINE OUT jacks of
your Wireless Receiver
RCA cable (available separately)
RCA input jacks of
a stereo receiver or
AV Amplifier