User's Manual
Table Of Contents
- Creative Sound Blaster Wireless Music
- Contents
- Introduction
- Your Sound Blaster Wireless Music At A Glance
- Getting Started
- Using Your Remote Control
- Configuring Settings
- About Music Files
- Frequently Asked Questions
- Maintenance and Safety Advice
- Technical Specifications
- Glossary
- Ad-hoc mode
- Antenna
- Access Point (AP)
- Bandwidth
- BSS (Basic Service Set)
- DHCP (Dynamic Host Configuration Protocol)
- Dynamic IP address
- Encryption
- IEEE 802.11
- IEEE 802.11b
- IEEE 802.11g
- Infrastructure mode
- IP (Internet Protocol)
- IP address
- LAN (Local Area Network)
- MAC (Media Access Control) address
- Router
- SSID (Service Set Identity)
- Static IP address
- TCP/IP (Transmission Control Protocol/ Internet Protocol)
- USB (Universal Serial Bus)
- WEP (Wired Equivalent Privacy)
- Wi-Fi
Getting Started 3-10
Step 4: Play
Music
1. Insert three AA batteries into the Remote Control..
2. Press the Power button on your Remote Control.
Your Remote Control is automatically assigned to your Wireless Receiver if you
have only one Wireless Receiver installed on your wireless network. If not, you
will need to manually assign the Remote Control to the Wireless Receiver that
you are installing. For more information, see
"To assign a Remote Control to a
Wireless Receiver" on page 4-1
3. When the main menu appears on the LCD, click the Play button on your
Remote Control to start playing tracks in the PC Music Library.
Make sure your
Remote Control is no
more than 10 meters
(33 feet) when you set
up and use your
Remote Control.
Figure 3-9: Inserting batteries into the Remote Control