User's Manual
Table Of Contents
- Creative Sound Blaster Wireless Music
- Contents
- Introduction
- Your Sound Blaster Wireless Music At A Glance
- Getting Started
- Using Your Remote Control
- Configuring Settings
- About Music Files
- Frequently Asked Questions
- Maintenance and Safety Advice
- Technical Specifications
- Glossary
- Ad-hoc mode
- Antenna
- Access Point (AP)
- Bandwidth
- BSS (Basic Service Set)
- DHCP (Dynamic Host Configuration Protocol)
- Dynamic IP address
- Encryption
- IEEE 802.11
- IEEE 802.11b
- IEEE 802.11g
- Infrastructure mode
- IP (Internet Protocol)
- IP address
- LAN (Local Area Network)
- MAC (Media Access Control) address
- Router
- SSID (Service Set Identity)
- Static IP address
- TCP/IP (Transmission Control Protocol/ Internet Protocol)
- USB (Universal Serial Bus)
- WEP (Wired Equivalent Privacy)
- Wi-Fi
Configuring Settings 5-1
Configuring Settings
You can configure settings using the SB Wireless Music Application. For more
information about using SB Wireless Music Application, refer to its online help.
To launch the SB Wireless Music Application
Click Start -> Programs or All Programs -> Creative -> SB Wireless
Music -> SB Wireless Music Application.
Configuring
Your Wireless
Receiver
1. In the SB Wireless Music Application, click the Settings button.
2. Click the SB Wireless Music Device tab.
3. Select your Wireless Receiver from the list box, and click the Edit button.
4. Change the settings of your Wireless Receiver and click the OK button.
Figure 5-1