User's Manual

Table Of Contents

ADDICT v3.0.1 User Manual DALI Functionality

If a lamp is removed from a device, it is assigned with the next address, and the instruction of

the screen changes to the following:

The ADDICT

will then wait until the lamp is reconnected. Once the lamp is reconnected, the

ADDICT

will visually confirm that the device has been addressed:

During visual confirmation, the lamp will flash three times if it has been addressed. It will only

flash once if it already had an address and it was not assigned the new address.

After visual confirmation, the “Remove lamp” screen will once again be displayed. When all the

devices on the DALI line have been addressed, the following screen will be shown:

If Live Preview is enabled, a “Minimum” command is sent to all devices at the commencement of

physical selection, and then once a device has been addressed, it will be sent a “Maximum”

command. If Live Preview is disabled, visual confirmation will still occur, but afterwards the

device will return to its previous level.

Selectable values:

• Confirmation (YES, NO) – Press enter with YES selected to confirm random addressing,

NO to cancel.

Note: Some DALI devices are not capable of detecting when their lamps are removed, however

these devices may be fitted with a push button or similar that mimics a removed lamp for

physical selection.