User's Manual

ADDICT v3.0.1 User Manual DALI Functionality
©2017 All rights reserved - 20 -
The values for the Defaults? setting is yes/no, and selecting yes and pressing enter will cause the
settings for the device to be reset back to factory defaults.
Although current values can’t be retrieved for groups of devices in DALI (as multiple devices
would have to simultaneously reply), Cfg Settings can still be used to change the settings for
groups of devices, but confirmation won’t be available unless an address within that group is
selected.
If Live Preview is enabled:
• Selecting an address/group will cause that address/group to be set at maximum and all
others at minimum
• Selecting a value for a setting with a level will cause a “Go to level” command to be sent
to the selected address/group.
Selectable values:
• Address/Group (Address:0-63, Group:0-15, Devices:ALL) – The address or group of the
device(s) to configure the settings for.
• Setting (Minimum, Maximum, Sys Fail, Power On, Fade Time, Fade Rate, Defaults?) – The
setting to configure or reset to defaults
• Setting Value (various ranges of values depending on setting) – Pressing enter will save
any changes made to the selected setting.
Groups
Config Groups provides a more comprehensive and alternative method of adding and removing
devices to DALI groups (when compared with Installation → Assign Groups.)
The address or group selected in the second line is the device that is being added to, or removed
from, a DALI group. The group chosen in the third line is the group being added to, or removed
from. Since both values can be groups, values always have their “line” indicated in this section
to remove the ambiguity.
When an address for a device that is on the line is selected (2
nd
line of screen text), its current
assignment to the selected DALI group (3
rd
line of screen text) is displayed next to “assigned” as
either yes (is assigned to the group) or no (is not assigned to the group).
When a group is selected (2
nd
line of screen text), the current assignment to the selected DALI
group (3
rd
line of screen text) cannot be shown, and the yes/no option will not be available until
the user navigates down to “assigned”.
The final line of screen text sets whether the selected device(s) (2
nd
line of screen text) should be
assigned to the selected DALI group (3
rd
line of screen text). Confirmation is provided for