User's Manual

ADDICT v3.0.1 User Manual DALI Functionality
©2017 All rights reserved - 23 -
However, not all possible combinations are valid, and the following table outlines the scenarios
available when copying scenes:
Source
Target
Result
Device
Scene
Device
Scene
Address
0 – 15
Address or
Group
0 – 15
The selected scene from the source device is copied to
a scene in the target device(s).
Address
0 – 15
Address or
Group
ALL
The selected scene from the source device is copied to
all the scenes in the target device(s).
Address
ALL
Address or
Group
ALL
All scene levels from the source device are copied to
the scenes in the target device(s) (scene 0 copied to
scene 0, scene 1 copied to scene 1 etc.)
Group
0 – 15
Same as source
group
0 – 15
For each device in the source group, the source scene is
copied to the target scene.
Group
0 – 15
Same as source
group
ALL
For each device in the source group, the source scene is
copied to all the scenes.
If Live Preview is enabled:
• Selecting an address/group will cause that address/group to be set at maximum and all
others at minimum.
• Selecting a scene will cause that scene to be recalled for the associated source/target
device.
Selectable values:
• Source (next to “From”) device (A00-A63, G00-G15, ALL) – The address or group of the
device(s) containing the source scene(s).
• Source scene (0-15, ALL) – The scene(s) to be copied from the source device(s).
• Target (next to “To”) device (A00-A63, G00-G15, ALL) – The address or group of the
device(s) the scene(s) is being copied to.
• Target scene (0-15, ALL) – The scene(s) being copied to. Pressing enter will cause the
copy function to be performed.
Swap Scenes
Swap Scenes allows for scenes to be swapped between devices.
To swap scenes, two devices and the two scenes to be swapped must be selected. It is also
possible to select a group as a device and all scenes as a scene to be swapped. However, not all
possible combinations are valid, and the following table outlines the scenarios available when
swapping scenes: