User's Manual

ADDICT v3.0.1 User Manual DALI Functionality
©2017 All rights reserved - 34 -
Count Devices
Count Devices scans the DALI line and displays a count of the number of addresses, groups and
reported lamp failures currently on the line. During scanning, a progress bar is displayed as
shown in the following:
The following example shows that 10 addresses were detected on the DALI line, as well as 4
groups and one of the 10 addressed devices is reporting a lamp failure.
Press enter or escape to return to the menu.
Check Failures
Check Failures scans the DALI line for devices reporting that their lamps have failed. If any
devices report a failure the ADDICT
®
will display which addresses have lamp failures and which
do not.
The following examples show that the device with address 29 is reporting a lamp failure and the
device with address 45 isn’t reporting a lamp failure.
The address is selected using the increase + and decrease - buttons. If Auto-scan is disabled,
only addresses reporting lamp failures can be selected.
Note: some DALI devices are unable to detect when they have a failed lamp, so they will not be
able to report lamp failures. Also, the status of the lamp failure for a selected address is not
updated while that address is selected, but will be updated when the address selection is
changed.
Selectable values:
• Address (0 – 63) – The address of the device being interrogated for a lamp failure