User's Manual

Table Of Contents

ADDICT v3.0.1 User Manual DALI Functionality

Capture All

Capture All will capture the stored settings for all devices currently connected to the DALI line

and associate them with the same bus ID.

The first screen displayed for Capture All selects the bus ID that will be associated with the

stored settings. As a bus ID is being selected, the number of devices currently stored with that

bus ID is also shown.

The following examples show that bus ID 4 already has 21 devices stored for it, and bus ID 56

currently has none:

After a bus ID has been selected, the ADDICT

will scan the DALI line to check how many new

slots will be required, and how many slots will be updated (if the bus ID and address

combination already exists). It also briefly shows how many slots are not currently being used.

If the number of new slots is more than the number of free slots, Capture All will not proceed.

The ADDICT

will ask for confirmation before capturing the stored settings, as shown in the

following example (the example also shows the “free slots” before confirmation is asked):

After confirmation, the ADDICT

will capture and store the settings from all devices on the

currently connected DALI line.

Selectable values:

• Bus ID (0 – 99) – the bus ID to associate with the stored settings

• Confirmation (YES, NO) – Press enter to confirm Capture All, YES to start capturing, NO to

cancel

Capture 1 by 1

Capture 1 by 1 stores the common settings for just a single device on the DALI line. When

storing the settings, the selected address and bus ID will be checked to see if the selected

combination is already in use, in which case the current settings stored in the ADDICT

will be

overwritten. Otherwise, a new memory slot will be used for the settings.

During selection of the bus ID and device address, the ADDICT

will indicate whether a new slot

will be required or old data will be updated, as shown in the following examples: