User's Manual

Table Of Contents

ADDICT v3.0.1 User Manual DALI Functionality

After the bus ID and address have been selected, the ADDICT

will ask for confirmation for

capturing. If a new slot is required and there isn’t a free slot available, capturing will not

proceed.

Selectable values:

• Bus ID (0 – 99) – the bus ID to associate with the stored settings

• Address (0 – 63) – the address of the device to store the common settings for. Press

enter to proceed to confirmation

• Confirmation (YES, NO) – Press enter to confirm Capture 1 by 1, YES to start capturing,

NO to cancel

View Stored

View Stored allows a bus ID to be selected and then addresses associated with that bus ID can be

viewed (within the data stored in the ADDICT

The following examples show that there are stored settings for address 2 with bus ID 15, and

address 50 with bus ID 50.

Note: only one address is displayed at a time, and other addresses for the selected bus ID can be

displayed by navigating down to the address.

A bus ID of “ALL” can also be selected, which shows how many slots out of the total of 250 are

currently being used:

Selectable values:

• Bus ID (0 – 99, ALL) – the bus ID’s used when storing settings (only used bus ID’s can be

selected)

• Address (0 – 63) – one of the addresses associated with the selected bus ID