User's Manual

ADDICT v3.0.1 User Manual DALI Functionality
©2017 All rights reserved - 39 -
Programming
Programming is used to copy the stored settings for a device (obtained by capturing) from the
ADDICT
®
into a DALI device. Refer to the section on Capturing on page 35 for more information
regarding storing settings for a device.
The following four menu items are found under Programming:
• Program All
• Program 1 by 1
• View Stored
• Recv. from PC
Program All
Program All is used to copy the stored settings for all the devices associated with a selected bus
ID.
When using Program All, the ADDICT
®
will try to match up addresses stored in the ADDICT
®
for
the selected bus ID to those of the devices currently on the DALI line to which the ADDICT is
connected. It will then display how many addresses matched, how many were not found on the
line (but are stored in the ADDICT
®
) and how many were not stored in the ADDICT
®
(but are
connected to the DALI line).
In the following example, bus ID 47 is selected, and after scanning the DALI line, 6 addresses in
the stored settings for bus ID 47 matched addresses on the line, 2 addresses that were stored
were not found on the DALI line, and 11 addresses found on the DALI line were not in the stored
settings:
Confirmation is still required before the settings of the device(s) on the DALI line are
programming. If there are no matching pairs of addresses found, it is not possible to select YES
for the confirmation.
Once confirmed, the ADDICT
®
will program the settings for the device(s) with matching
addresses, displaying how many devices have been programmed and how many did not have
matching addresses and were therefore skipped.
The following example shows the screen when it’s currently up to programming address 24 and
5 devices (with addresses less than 24) have been programmed and 8 have been skipped:
Selectable values: