User's Manual

Table Of Contents

ADDICT v3.0.1 User Manual DMX512 and RDM (Remote Device Management) Functionality

It is also possible that the controller generating the DMX512 signal may not be sending levels for

all 512 channels, and the ADDICT

indicates this by showing a channel level as “---“ if it hasn’t

received a level for that channel.

RDM Setup – Identify All

Identify All sends a command to all RDM compliant devices (currently connected via the DMX512

interface cable) instructing them to begin their identification procedure.

How a device should identify itself is not specified by RDM, and the response to an identify

command depends on the device’s manufacturer (some may flash the lamp, display something

on an LCD etc).

Pressing escape will send a command to stop identification and then return to the RDM Setup

menu.

RDM Setup – Count Devices

Count Devices uses discovery commands to count how many RDM compliant devices are

currently connected via the DMX512 interface cable.

As devices are discovered, the number displayed will increase until all devices have been

counted, at which time the last line of the display will also read “Complete”.

Pressing escape while devices are being counted will return to the RDM Setup menu. Once

counting is complete, pressing enter or escape will return to the menu.

RDM Setup – Setup Devices

Setup Devices allows you to scroll through the connected RDM devices connected, and view and

modify their current RDM-based settings. Note that not all RDM commands are currently

supported by the ADDICT

, but they may be included in future releases.