User's Manual Part 3

Pre-Ride Inspections

Sidestand

1. On level ground, straddle the motorcycle and bring it to

the fully upright position.

2. Move the sidestand up to the stored position and down

to the fully extended position several times. It should

move smoothly and quietly. Make sure the return spring

holds the sidestand tightly in place when the sidestand

is in the stored position. Adjust or replace a loose

spring.

3. Inspect the sidestand pivot bolt for looseness or wear.

Tighten or replace a loose or worn bolt.

4. Periodically test the sidestand safety switch for proper

operation. With the transmission in gear and brakes

applied, attempt to start the engine while the sidestand

is down. The engine should NEVER start in any gear

except neutral if the sidestand is down. If the engine

starts during this test, see your dealer for service.

Fasteners

1. Inspect the entire motorcycle chassis and engine for

loose, damaged or missing fasteners.

2. Tighten loose fasteners to the proper torque. See the

INDIAN MOTORCYCLE Service Manual or an authorized

INDIAN MOTORCYCLE dealer.

3. Always replace stripped, damaged or broken fasteners

before riding. Use genuine INDIAN MOTORCYCLE

fasteners of equal size and strength.