User's Manual Part 4

101
Maintenance
Brake Pads
Front Brake Pad Inspection
1. Remove the two acorn nuts
and one screw securing
the protective caliper
covers. Remove the
covers.
2. Use an inspection mirror,
positioned at the front side
of the caliper, to view the
friction material.
3. Reinstall the caliper
covers.
Torque: 18 ft-lbs (24 Nm)
Rear Brake Pad Inspection
1. Position the motorcycle on the sidestand with the
handlebars turned to the left.
2. Use an inspection mirror, positioned at the front side of
the caliper, to view the friction material.
Anti-Lock Brake System (ABS) Tone
Ring/Sensor Inspection
1. Visually inspect for
damaged teeth on the
front and rear ABS
tone rings. Inspect for
nicks and dents on the
face of the teeth. The
teeth edges should be
consistent in
appearance. If a tone
ring is damaged, see
your dealer for
replacement as soon
as possible.
2. Inspect for debris
adhering to the end of
the wheel speed
sensors. If contamination is observed, or if you are
unable to visually inspect, slide a thin towel across the
face of the sensor between the sensor and the tone ring
to remove any potential debris.
Front Caliper Cover Nuts
Tone Ring
Teeth
Wheel Speed
Sensor