User's Manual Part 2

28
Instruments, Features and Controls
Instrument Cluster (CHIEF)
The instrument cluster includes the speedometer, indicator
lamps and Multi-Function Display (MFD).
Speedometer
The speedometer displays forward vehicle speed in either
miles per hour or kilometers per hour.
Indicator Lamps
Indicator Lamps
Lamp Indicates Condition
Neutral The transmission is in neutral.
High
Beam
The headlight switch is set to high beam. This
indicator will flash if there is a problem with
the low or high beam light.
Speedometer
Indicator Lamps
MFD
Lamp Indicates Condition
Turn
Signal
The turn signal indicator flashes when the left,
right, or both turn signals (hazard) are active.
If there is a problem in the signal system, the
lamps will flash at twice the normal rate.
Cruise
Control
Status
Amber Lamp: Cruise control is enabled, but
not set. Green Lamp: Cruise control is set to
the desired speed. Read the safety and
operation procedures before using cruise
control. See page 76.
Check
Engine
If this lamp illuminates while the engine is
running, see your dealer promptly. The light
will remain on if the tilt sensor shuts down the
engine. If abnormal sensor or engine
operation is detected the light will remain on
as long as the fault condition exists. Retrieve
the error codes for diagnosis. See page 31.
Anti-Lock
Brakes
Not
Activated
The indicator remains on until the anti-lock
system activates, which occurs when vehicle
speed exceeds 6 MPH (10 km/h). When the
lamp is illuminated, the anti-lock brakes will
not activate, but the conventional brake
system will continue to operate normally.
Vehicle
Speed
When standard mode is selected, speed
displays in miles per hour.
When metric mode is selected, speed
displays in kilometers per hour.