User's Manual Part 3

50
Instruments, Features and Controls
Sidestand
The sidestand is equipped with a safety switch that prevents
operation of the motorcycle if the sidestand is deployed.
WARNING! An improperly retracted sidestand could contact the
ground and cause a loss of control resulting in serious injury or
death. Always retract the sidestand fully before operating the
motorcycle.
To park the motorcycle, swing the end of the sidestand
downward and away from the motorcycle until it is fully
extended. Always turn the handlebars to the left for
maximum stability. Lean the motorcycle to the left until the
sidestand firmly supports the motorcycle.
CAUTION! If the motorcycle weight is not resting on the sidestand,
it will not lock. In this situation, any movement of the motorcycle
could cause the sidestand to retract slightly. If the sidestand is not in
the full forward position when the motorcycle weight is rested on it,
the motorcycle could fall over, possibly causing injury and damage to
the motorcycle.
To retract the sidestand, straddle the motorcycle and bring
it to the fully upright position. Swing the end of the sidestand
upward and toward the motorcycle until it is fully retracted.
Saddlebags
Do not exceed the weight limit of each saddlebag. Always
distribute weight evenly in each of the saddlebags.
Hard bag capacity is 22 pounds (10 kg) of cargo per side.
Soft bag capacity is 15 pounds (6.8 kg) of cargo per side.
Soft Bag Removal
1. Unbuckle the saddlebag
lid clasps and open the
lid.
2. Flip the two quick-release
latches upward.
3. Tilt the saddlebag away
from the fender and lift
upward to remove it from
the spools.
WARNING! Improper saddlebag
installation can result in loss of
control, accident and driving
hazards for other motorists (if
saddlebag falls from the motorcycle). Always make sure saddlebag
mounting brackets are fully seated onto the spools before engaging
latches.
4. To reinstall, place the soft bag in position. Make sure the
mounting bracket is seated fully on the spool. Make sure
the rubber bushings on the latch pins are fully engaged
in the spools.
5. Engage the quick-release latches and flip them fully
downward.
Spool
Mounting Bracket
Latches