User's Manual Part 4

75
Operation
Braking
Always allow sufficient stopping distance so that brakes can
be applied gradually.
Tip: Applying slightly more front brake than rear brake generally
provides the best braking performance.
1. To slow the motorcycle with the brakes, close the throttle
and apply the front and rear brakes evenly and
gradually.
Tip: When the anti-lock brakes engage during a braking event, the
rider will feel pulsing at the brake levers. Continue to apply
steady pressure to the brakes for the best stopping
performance.
2. As the motorcycle slows, disengage the clutch, or
downshift each time vehicle speed reaches a downshift
point.
WARNING! Braking improperly could result in loss of control,
which could result in serious injury or death. Avoid braking abruptly.
Always apply the brakes gradually, especially on wet, slippery or
other low traction surfaces. Avoid braking in a curve or turn. Bring
the motorcycle to the upright position before applying the brakes.
Accelerating
Accelerate by opening the throttle (rolling the throttle
control grip rearward). For even acceleration, open the
throttle with a smooth, continuous motion. When you reach
the recommended speed for upshifting, shift up one gear.
WARNING! Accelerating abruptly could cause your body to shift
rearward suddenly, which could result in loss of control. Accelerating
abruptly could also cause loss of control on low traction surfaces.
Loss of control could result in serious injury or death. Always
accelerate gradually, especially on wet, slippery or other low traction
surfaces.
Stopping the Engine
Before stopping the engine, bring the motorcycle to a
complete stop. Shift to neutral or disengage the clutch.
WARNING! Stopping the engine with the transmission in gear
while the motorcycle is moving could cause loss of rear wheel
traction or engine and transmission damage, which could cause loss
of control and serious injury or death. Always stop the engine after
the motorcycle is fully stopped and the transmission is in neutral. If
the engine stops unexpectedly while the motorcycle is moving, guide
the motorcycle to a safe location off the road and away from traffic.
Turn the power switch off.
1. When fully stopped, shift into neutral.
2. Move the engine stop/run switch to the STOP position.
3. Turn the power switch off.