User's Manual Part 4

122
Cleaning and Storage
Clean and Protect the Motorcycle
To prepare the motorcycle for storage, begin by cleaning it
as outlined beginning on page 120. Wax painted surfaces
and polish chromed and other metal surfaces. Apply
protectant to exposed rubber, vinyl, and plastic parts.
Do not apply rubber protectant to the tire tread surfaces.
Fuel Stabilizer
Add fresh fuel to fill the fuel tank and add fuel stabilizer. Do
not overfill.
Ride the motorcycle or start and run the engine for 15
minutes in a well ventilated area to distribute the stabilizer
throughout the fuel system.
Tire Inflation
Inflate the tires to normal pressure. See page 104.
Engine Protection
Change the engine oil. See page 84.
Battery Care
1. Remove the battery. See page 110.
2. Clean the battery terminals first with a wire brush to
remove any loose deposits.
3. Wash the posts and the ends of the battery cables with a
solution of one part baking soda to 16 parts water. Rinse
with clean water and wipe dry.
4. Apply a thin film of dielectric grease to the posts and
cable connectors.
5. Clean the outside of the battery with a solution of mild
detergent and warm water.
6. Store the battery in a dry area with a temperature of 32°
to 90° F (0° to 32° C).
7. While in storage, fully charge the battery once a month.
See page 112.
Maintenance During Storage
During extended storage periods, maintain tire pressure
and battery voltage at the recommended levels.