User's Manual

10
Date of Origin – 02/01/08
LIGHTS AND REFLECTORS
The surfaces of the lights and reflectors need to be checked and cleaned. Inspect all lights to
see if they are working and check all brake and signal functions.
ELECTRICAL WIRING
Inspect all visible wiring to see that it is not frayed and is properly supported and protected, and
that all connections are tight. Inspect the electrical hookup for a clean and secure connection.
FIFTH WHEEL AND KING PIN ENGAGEMENT
Inspect the kingpin and its structure on the trailer for damage or unusual wear. After hook up,
make a direct visual inspection to assure proper coupling, then check for positive engagement of
the lower fifth wheel and king pin. Apply the trailer brakes and attempt to move the tractor forward
to insure that the fifth wheel and king pin are positively locked.
CAUTION! Plastic King Pin Liners (Lube Plate) cannot be installed onto Timpte Trailer
upper coupler/king pin assemblies unless the trailer was purchased with that specifi-
cation. A lube plate changes the king pin interface dimensions relative to the fifth
wheel lock. This may result in coupling difficulties, premature lock wear, and a poten-
tial for a dropped trailer.
TIRES
WARNING! DO NOT OVERLOAD! Check tires frequently for cuts and abrasions.
Check tire pressure daily and keep inflated as recommended by the tire manufacturer.
Remove foreign objects that may be lodged in the tire treads or between dual tires.
MUD FLAPS
Be sure the mud flaps are securely in place and in good condition.
!
!
TARP SYSTEM
Check to be sure the tarp is in serviceable condition. Insure that the latching system is in good
working order and that the tarp is properly secured for travel to prevent being blown about by the
wind.
LANDING GEAR
Always raise the landing gear legs completely before moving the trailer. Make sure that the crank
handle is properly secured. Prior to trailer transport, lock landing legs into low side gear ratio.