User's Manual

30
Date of Origin – 02/01/08
THUNDER TARP RF PROGRAMMING:
1. Power up the RF control module. Press and hold the 2 large “Open” and “Close” buttons for
3 seconds or until the light illuminates to indicate the system is activated.
2. Push and hold the small round button programming and the large “OPEN” button
simultaneously and hold for approximately 6 seconds. The red light will flash rapidly.
3. Open all transmitters to be programmed and observe flashing light to insure transmitter is active.
4. Push “Select” button to select “Tarp System” if flashing light is in another mode on all
transmitters to be programmed.
5. Press the “ON/OPEN” button on transmitter for one second to be programmed. The red light
will stop flashing momentarily and then start. Repeat for all transmitters to be programmed.
Four transmitters can be programmed to each control module so four inputs are required. If
one transmitter is being programmed, the “ON/OPEN” button will required to be pushed four
times. If two transmitters are being programmed then the last transmitter will be required to
press the “ON/OPEN” button three times. The light on the control module will stop flashing
when the four inputs have been received.
6. Close lid of programmed transmitters to power down transmitters.
7. Power down control module by pushing the “Open” and “Close” buttons for 3 seconds on the
power
module or transmitter.