User guide

Connecting With Other Devices 3-6
For example, to set your drive’s SCSI ID number at 1, enable pin 1,8
and disable pin2,9 and pin 3,10.
Ensure that no two devices along the SCSI bus have the same
ID number. For more information regarding SCSI bus, refer to
the section “SCSI Bus” on page 3-2.
Setting a Terminator
If your drive is an end device along the SCSI bus, you will have to
terminate your drive by enabling pin 6,13 (see Figure 3-6).
2 DED
3 EED
4 DDE
5 EDE
6 DEE
7 EEE
D represents a disabled jumper and
E represents an enabled jumper.
Table 3-2:Possible SCSI ID Numbers.
SCSI ID
Number
Pin
1,8
Pin
2,9
Pin
3,10
Figure 3-6: Terminator jumper enabled.