User Manual

Installing Video Blaster WebCam 3 1-5
4. Insert the Video Blaster WebCam CD into your CD-ROM drive.
Note: If the setup program runs automatically, exit from the program.
5. In the dialog box, select the Specify a location check box and type D:\DRIVERS
(where D: represents your CD-ROM drive) in the box provided.
6. Click the Next button.
7. Click the Next button again.
i. If you are prompted to insert the Windows 98 CD, proceed to step 7ii.
Otherwise, skip to step 8.
ii. In the CD-ROM drive, replace the
Video Blaster WebCam CD
with the Windows 98 CD.
iii. In the
Insert Disk
dialog box, click the
OK
button.
iv. In the
Copying Files
dialog box, click the
Browse
button.
Locate and select the
Win98
folder within the Windows 98 CD.
Click the
OK
button.
v. Click the
OK
button again.
8. When the drivers are installed, click the Finish button.
9. Proceed to install the applications for WebCam 3.
In the CD-ROM drive, insert the Video Blaster WebCam CD.
You may have to remove the Windows 98 CD first.
The setup program runs automatically and a dialog box listing the available applications
appears.
10. Select Video Blaster WebCam Control and the other applications you want to install. Do
not, however, select Internet Explorer (IE) 5.0.
A check mark indicates that an application is selected.
Note: If you want to install IE 5.0, do the following
after
Step 11 is completed: run
D:\CTRUN\CTRUN.EXE and select only the IE 5.0 application.
11. Follow the instructions on the screen to complete the installation.
You may be asked, after an application is installed, if you want to restart your computer.
Select No until all the drivers and applications you selected are installed.
Then restart your computer.