User guide
Troubleshooting 34
))
"<
(,
This may occur when a SoundFont-compatible MIDI file is loaded or played.
Cause: There is insufficient memory allocated to SoundFonts.
To allocate more SoundFont cache:
• On the Options tab page of SoundFont Control, move the SoundFont Cache slider to the right.
The amount of SoundFont cache you can allocate depends on the system RAM available.
If there is still insufficient system RAM available:
• On the Configure Banks tab page of SoundFont Control, select a smaller SoundFont bank from the
Select Bank box. The smallest SoundFont bank available is 2 MB (
2GMGSMT.SF2
).
12
-%%"
The audio card’s joystick port conflicts with the system’s joystick port.
To solve this problem:
• Disable the audio card’s joystick port and use the system port instead.
-%%""
The program may use the system processor timing to calculate the joystick position. When the processor
is fast, the program may determine the position of the joystick incorrectly, assuming that the position is
out of range.
To solve this problem:
• Increase your system’s 8 bit I/O recovery time of the BIOS setting, usually under the Chipset Feature
Settings section. Or, if available, you may adjust the AT Bus speed to a slower clock. If the problem
persists, try a different joystick.
Do not attempt to make changes to
the BIOS unless you have
experience with system software.