Operation Manual
Troubleshooting B-2
Problems with
Sound
No sound from the headphones.
Check the following:
❑
The headphones are connected to the Headphones jack.
❑
Make sure that the Headphones Volume control is not muted.
❑
The Digital/Analog switch is set to Digital/Analog mode.
No sound from the speakers.
Check the following:
❑
You have connected your speakers to Sound Blaster's output.
❑
You have selected the correct source in Creative Surround Mixer.
❑
Headphones are not connected to Sound Blaster. Output to the speakers is
automatically cut off when headphones are connected.
❑
Make sure that in Creative Surround Mixer, the
Mute
check box for that source
does not have a check mark in it.
❑
The Digital/Analog switch is set to Digital/Analog mode.
No audio output when playing digital files such as .WAV, MIDI files or AVI clips.
Check the following:
❑
The speakers’ volume control knob, if any, is set at mid-range. Use Creative
Surround Mixer to adjust the volume, if necessary.
❑
The powered speakers or external amplifier are connected to Sound Blaster’s
output jacks.
❑
The Speaker selection in the Creative Speaker Console corresponds to your
speaker or headphone configuration.
❑
Make sure that in Creative Surround Mixer, the
Mute
check box for that source
does not have a check mark in it.
❑
The speakers are powered up and turned on.