Specifications

CREATOR CHINA 2013-08 WWW.CREATOR1997.COM
42
CROSS series mixed matrix switch User 's Manual
CROSS Series Mixed Matrix Switcher User 's Manual
ASCII
Instructions
(Computer to
the matrix)
Command functions
Return(matrix to
computer)
For example
Fastswitch.
Switch to a fast mode (default)
FASTSWITCH!
Fastswitch.
RWEDID.
Load the first output port of the EDID to all
input port
EDID-OK!( success)
EDID-FAIL!(Failure)
RWEDID.
DefaultEDID.
Restore the system default EDID to all
input port
EDID-OK!
DefaultEDID.
[Y1]D[X1],
[X2],…[Xn].
Read the monitor EDID connected to port
[Y1] to the input port [X1], [X2],... , [Xn].
When the output port [Y1] equals 0,it
means that restores the default EDID to
the corresponding input port
1D1,2,3,4,5,6,7,8.) As input ports [Xn] are
required in the same layer of the input
card, so only 8 roads can be written at one
time (for example: 1D1,2,3,4,5,6,7,8.)
EDID-OK!( success)
EDID-FAIL!(Failure)
1D1,2,3,8.
COMP8 input and output card control instruction table
ASCII
Instructions
(Computer to
the matrix)
Command functions
Return(matrix to
computer)
For example
COMP8 card commands - set active command to card port
(Note: Activate the card port before the corresponding port parameter settings)
[X1],[X2],…,[Xn]
SETIN.
Enter the input card debugging mode,
activate the port of COMP8 input card (the
maximum number is up to 40) and it will
automatically exit debugging mode without
any operation in 10 minutes.
Note: Only one input port can be activated
during query; output card debugging mode
automatically exit after the use of the
command, and the port activated by input
card debugging mode automatically become
invalid .
Command OK!
1,2,3,4SETI
N.
[Y1],[Y2],…,[Yn]
SETOUT.
Enter the output card debugging mode,
activate the port of COMP8 output card (the
maximum number is up to 40) and it will
automatically exit debugging mode without
any operation in 10 minutes.
Note: Only one output port can be activated
during query; input card debugging mode
Command OK!
1,2,3,4SETO
UT.