User manual

Connecting the VS-66HDCP 6 x 6 DVI Matrix Switcher
9
9
6 Connecting the VS-66HDCP 6 x 6 DVI Matrix Switcher
To connect the VS-66HDCP, as the example in Figure 2 illustrates, do the
following
1
1. Connect up to six DVI sources
:
2
2. Connect the SELECT OUT DVI connectors to up to six DVI
acceptors
(for example, computer graphics
sources) to the SELECT IN DVI connectors.
3
3. If required, connect a PC and/or controller to the RS-232 port (see
section
(for example, DVI displays).
7.5) and/or the ETHERNET port (see section 7.6).
4. Connect the power cord (not shown in
Figure 2).
5. If required, acquire the EDID (see section
7.4).
1 Switch OFF the power on each device before connecting it to your VS-66HDCP. After connecting your VS-66HDCP,
switch on its power and then switch on the power on each device
2 You do not have to connect all the sources
3 You do not have to connect all outputs