Tumble Dryer Instruction Book 5kg Models You must read these instructions prior to using the appliance and retain them for future reference.
Contents Safety Advice Electrical Requirements Features - Get to know the main parts of your Dryer Where to put and vent your Dryer How to use your Dryer The Controls Sorting your laundry Wash Care Labels Items not suitable for tumble drying Items requiring special attention Speedy Iron Programme Guide to Drying Times How to remove and clean the fluff filter Caring for your Dryer If something goes wrong Key Contacts 3-4 5 6 7-8 9 10-13 14 15 15 16 17 18 19 20 22 Back Cover Retention of this Instruction Bo
For your safety IMPORTANT Using your Tumble Dryer is easy. Nevertheless, for your own safety and to get the best results it is important to know your Dryer by reading right through this handbook before using your dryer for the first time. NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER NEVER ● Allow children to play with or otherwise interfere with the dryer.
For your safety ALWAYS ● When the dryer is not in use, switch off at the wall, remove plug and close the door. ALWAYS ● Comply with the specified electrical requirements. ALWAYS ● Ensure that your dryer is installed correctly and has adequate ventilation. (see, "Where to put and vent your dryer.") ALWAYS ● Use the vent hose for optimum drying performance. ALWAYS ● Finish every programme with the cool tumble cycle provided on the control.
Electrical Requirements WARNING: This appliance must be earthed! Supply REFER TO THE RATING PLATE FOR VOLTAGE AND CURRENT REQUIREMENTS. (see diagram for location.) The flexible mains lead is supplied fitted with a BS1363 plug and with a 13 amp BS1362 fuse. The plug should be connected to the mains supply via a suitable switched socket which is accessible after installing your dryer. Changing the fuse If it is necessary to fit a replacement fuse, it must be a 13 amp ASTA approved to BS1362 type.
Features - Get to know the main parts of your dryer See “The Controls” NOTE: if your dryer is new wipe out the inside of the drum before you first use it to remove any dust which may have accumulated during transit. Drum Model and serial numbers FLUFF FILTER Clean after each use Fig. 2 Front vent with hose (Vent cover at rear) Fig. 1 Rating Plate Air Intake grill Vent Cover Fig. 4 Caution Hot Fig.
Where to put and vent your dryer ● Your tumble dryer should NOT be located adjacent to a gas hob, cooker, heater, or eye level grill as flames from the burners could cause damage to your machine. ● When the dryer is fitted under a work surface, allow space for air to enter the rear grille, 10mm above the dryer minimum. ● If you are using this dryer adjacent or stacked on top of a washing machine SEPARATE mains plugs and sockets must be used for each appliance. DO NOT use 2-way adaptors or extension leads.
Where to put and vent your dryer Permanent Venting In conjunction with the vent hose we recommend the use of a Wall/Window Vent Kit. These are available from your retailer or nearest Spares Centre. Wall/Window Venting Fitting instructions are supplied with the kits, which can be mounted through a wall or window. Details of positioning for wall mounting are as follows:- Break a hole through the wall to the left of the proposed position for the dryer.
How to use your dryer 1. Plug in, switch on electricity. WARNING: WHEN SWITCHING ELECTRICITY ON OR OFF, PLEASE ENSURE THAT YOUR HANDS ARE DRY. 3. Open the door. Check that the fluff filter is clean (see section How to remove and clean the fluff filter). 5. Select the relevant heat setting (see section “Sorting Your Laundry”). When low heat is selected a coloured indicator (on top of switch) will be visible. 6. (Selected models only) Select Alarm (Buzzer) option, if required.
The Controls - Basic Models (not 2-way Tumble models) Heat Switch (OUT low heat, IN high heat) Indicator Timer control Turn the timer clockwise from the zero position slightly past the required time, then back to the required time. The drying time for both heat settings is controlled by the timer. Do not rotate the knob beyond 120 minutes (maximum drying time), or past the zero stop. If you have selected more time than you require turn the knob anti-clockwise to select the correct time required.
The Controls - Reverse (2-way Tumble models) Heat Switch (OUT low heat, IN high heat) Indicator Timer control Turn the timer clockwise to select the required drying time. The drying time for both heat settings is controlled by the timer. All you have to do is turn the Timer Control clockwise until the required time appears in line with the indicator. Never wind the timer control anti-clockwise. This operation also starts the dryer, provided the door is closed and the machine is plugged in.
The Controls - Excel Auto Sensor models Heat Switch (OUT low heat, IN high heat) Sensor Drying Light Alarm Switch Indicator To set the required programme, all you have to do is turn the Timer Control clockwise until the required selection appears in line with the indicator. Never turn the timer control anti-clockwise. This operation also starts the dryer, provided the door is closed and the machine is plugged in. Programme options 1. Sensor (Automatic) Drying B (average) loads 2.
The Controls - Auto Sensor models (continued) Sensor Drying Light This light will glow when Sensor Drying is selected. it will stop glowing when the load is dry and the programme advances to the Cool Tumble phase. ii) Speedy Iron Cycle This is a short programme of approximately 10 minutes to condition previously dried clothes (See section “Speedy Iron Programme”). It consists of a period of heating followed by a short cool tumble period (as detailed below). Select high heat for this programme.
Sorting your laundry 1. Always separate laundry into the correct fabric groups before washing and drying. 2. See that all zips are closed, hooks and eyes are fastened and belt, strings etc. are tied loosely in bows, you will normally have done this for each item before the washing stage. 3. It is important to extract as much water as possible from each item before drying. This saves you time and money. WARNING: CLOTHES SHOULD NEVER BE LOADED DRIPPING WET 4.
Wash Care Labels Most of today’s fabrics can be tumble dried in your Dryer with no trouble at all, but there are certain fabric finishes which should be dried away from direct heat. The majority of garments now have wash-care labels on them, giving full washing and drying instructions. These should always be followed carefully especially when you are drying something for the first time.
Items requiring special attention Blankets and Bedspreads The drying requirements of blankets and bedspreads will, of course, vary tremendously according to size and weight. Some, however are simply too big. if you have difficulty getting them into the Dryer, the machine will have difficulty drying them properly. Blankets (and Garments) made from Acrylic fibres (e.g. Acilan, Courtelle, Orion and Dralon) must be dried with special care on Low heat setting.
Speedy Iron Programme - Selected models ‘Speedy Iron’ provides a short programme consisting of approximately 7.5 minutes of heat with an approximately 2.5 minutes cool tumble period. It is a short conditioning programme that softens the fibres allowing them to relax making handling and ironing easier and less time consuming.
Guide to Drying Times Please note that the Drying Times stated below and on appliance control panel are a GUIDE only and drying times are affected by: Items such as towelling retain a lot of water after spinning, also the The amount of water remaining in suggested wash programme for small items such as T-Shirts may sometimes incorporate a low spin speed which has the same effect. the clothes after spinning The type of fabric Your drying load may contain the same type of fabric but of different thicknesses.
How to remove and clean the fluff filter Position of filter WARNING: NEVER USE SHEET FABRIC CONDITIONER. IT MAY FALL INTO THE FILTER AND RESTRICT THE AIRFLOW THROUGH THE DRYER To remove the filter A very important part of your dryer is the fluff filter at the front edge of the drum. It’s there to trap the particles of lint and fluff which are normally blown away when clothes are dried on the washing-line.
Caring for your Dryer Your tumble dryer needs very little attention. The following simple steps will keep it performing well. When finished Switch off electricity and remove plug. After each load Always clean the filter and turn the drum by hand to check that small items like handkerchiefs do not get missed. As necessary Clean exterior metal and plastic surfaces with a damp cloth or silicon polish only.
Spare parts Please remember your new appliance is a complex piece of equipment. ‘DIY” repairs or unqualified and untrained service people may put you in danger, could damage the appliance, and might mean you lose cover under the Parts Guarantee. If you do experience a problem with the appliance don’t take risks, call in our Ser vice Engineer. Our Spare Par ts are designed exclusively to fit your appliance. Do not use them for any other purpose as you may create a safety hazard.
If something goes wrong First, don’t panic! There may be nothing wrong at all. Look for your problem below, then check the things we suggest. More often than not, this will give you the answer to your problem, and you’ll be able to carry on without having to telephone your Service Centre. If after this you still cannot get your machine to work, follow the advice given on the next page. Problem Check these things first ‘It won’t start’ 1. 2. 3. 4. 5. ‘It is taking a long time to dry’ (All Models) 1.
Key Contacts Service Creda has the largest appliance manufacturer’s service team in Europe, trained specialists directly employed by us to ensure your complete confidence. Repair Service UK: 08709 066 066 Republic of Ireland: 1850 302 200 You will be asked for the following information:Name, address and postcode.
